Lucent Technologies 5ESS - Delete Existing SIP PHE2 IP Processor Group

Delete Existing SIP PHE2 IP Processor Group
....................................................................................................................................................................................................................................
Purpose
This section contains the procedure for deleting an existing SIP PHE2
IP processor group.
When to use
Use this procedure to delete an existing SIP PHE2 IP processor group.
Related information
Refer to 235-118-258, Recent Change Reference for information on
the RC/V system.
Refer to 235-080-100, Translations Guide, for information on Office
Records (output reports).
Refer to the 235-600-700/750, Input/Output Messages manuals for
additional information on the Input and Output commands.
Refer to 235-105-331, Hardware Change Procedures - Degrowth for
information on degrowth of the PHE2.
Admonishments
None.
Before you begin
Required Tools
• Supplemental Trunk Line Workstation (STLWS) or Recent
Change and Verify (RC/V) terminal
• Access to RC/V Menu Interface
Required Material
• The 5ESS
®
switch must be running a 5E16.2 FR3 software
release or later with the SIP for Packet Trunking - NAR feature
software.
Required Information
• GSM Number
• Processor Group number
Deprovisioning
....................................................................................................................................................................................................................................
235-200-118
Issue 3.02B, March 2007
Lucent Technologies
6-109