Collect Data from Office Records
....................................................................................................................................................................................................................................
Purpose
This procedure provides the steps to obtain data that is required in
procedures throughout this chapter.
The following office records and associated data can be obtained from
this procedure:
• Packet Group (Office Record: 5219)
• GSM (Office Record: 5880)
• Provisioned Processor Groups (Office Record: 5883)
• SCTP Near Endpoint (Office Record: 5886)
• SCTP Association Name (Office Record: 5889)
• SCTP Association Set Name (Office Record: 5890)
• IP Processor Assignment (Office Record: 5987)
• IP Interface Assignment (Office Record: 5988)
• Ethernet IP Interface Assignment (Office Record: 5995)
• UDP Path (Office Record: 5891)
• SIP PSTN Interworking Parameter Set (Office Record: 5893)
• Inter-Nodal Trunk Group Identifier (Office Record: 5894)
When to use
Use this procedure for identifying GSM and SCTP-based endpoints,
associations, or association sets, and UDP Paths. This procedure is
listed as a prerequisite in each procedure that requires the identified
data.
Related information
Refer to the Input Messages Manual, 235-600-700, and the Output
Messages Manual, 235-600-750, for additional information.
Admonishments
None.
Before you begin
Required Tools
• Use of the Master Control Center (MCC) or Supplementary
Trunk Line Workstation (STLWS).
Required Material
• The switch must be running a 5E16.2 FR3 software release or
later with the SIP for Packet Trunking feature software.
Maintenance Considerations
....................................................................................................................................................................................................................................
7-4
Lucent Technologies 235-200-118
Issue 3.02B, March 2007
To Next Page
Loading...
