EasyManua.ls Logo

Lucent Technologies 5ESS - Remove SCTP Association

Lucent Technologies 5ESS
552 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Remove SCTP Association
....................................................................................................................................................................................................................................
Purpose
This procedure requests the removal of an SCTP association.
When to use
Use this procedure when the removal of an SCTP association is
required.
Related information
Refer to the Input Messages Manual, 235-600-700, and the Output
Messages Manual, 235-600-750, for additional information.
Admonishments
Unconditionally removing an association can be service-affecting
causing the shutdown of traffic.
Before you begin
Required Tools
Use of the Master Control Center (MCC) or Supplementary
Trunk Line Workstation (STLWS).
Required Material
The switch must be running a 5E16.2 FR3 software release or
later with the SIP for Packet Trunking feature software.
Required Information
Association number to be removed is known.
Required Conditions
Association status is not already
CLOSED.
Procedure
............................................................................................................................................................
1
Request a removal of a specific association:
RMV:SCTP,ASSOC=b,[UCL];
Where:
b = association number
Result:
Reports the result of removing a specific association from
service.
............................................................................................................................................................
2
If the result is NG - INVALID ASSOCIATION ID, then check the
association number on RC/V 33.22. For all others, refer to the Output
Messages Manual, 235-600-750, for additional information.
Maintenance Considerations
....................................................................................................................................................................................................................................
7-66
Lucent Technologies 235-200-118
Issue 3.02B, March 2007

Table of Contents

Related product manuals