Delete SIP Signaling from an Existing SIP Network
....................................................................................................................................................................................................................................
Introduction
This section contains additional procedures that might be required for
deprovisioning all or part of the SIP signaling network.
List of procedures
Below are additional steps for deprovisioning the SIP application. This
section assumes the reader is knowledgeable about the RC/V system
and the reading of office records. More procedural information can be
found in the links that are listed within the steps.
1. “Delete SIP PHE2 from Existing Duplex SIP IP Processor
Group” (6-89)
2. “Delete an Existing SIP Call-Processing SM” (6-92)
3. “Delete Packet Trunking to Another Office” (6-94)
4. “Delete Association Set to Another Office” (6-97)
5. “Delete SCTP Associations from Existing Association Set” (6-99)
6. “Delete Existing SCTP Association to SCTP Far Endpoint”
(6-101)
7. “Delete SCTP Near Endpoint” (6-107)
8. “Delete Existing SIP PHE2 IP Processor Group” (6-109)
Deprovisioning
....................................................................................................................................................................................................................................
6-88
Lucent Technologies 235-200-118
Issue 3.02B, March 2007
To Next Page
Loading...
Need help?
General
