Add New SIP Call-Processing SMs
....................................................................................................................................................................................................................................
Purpose
This section contains the procedure for adding a new SIP
call-processing SM.
When to use
Use this procedure to add a new SIP call-processing SM.
Related information
Refer to 235-118-258, Recent Change Reference, for information on
the RC/V system.
Refer to 235-080-100, Translations Guide, for information on Office
Records (output reports).
Refer to the 235-600-700/750, Input/Output Messages manuals for
additional information on the Input and Output commands.
Admonishments
None.
Before you begin
Required Tools
• Supplemental Trunk Line Workstation (STLWS) or Recent
Change and Verify (RC/V) terminal
• Access to RC/V Menu Interface
Required Material
• The 5ESS
®
switch must be running a 5E16.2 FR3 software
release with the SIP for Packet Trunking - NAR feature software.
Required Information
• SIP GSM numbers
• CP SM number(s)
Required Conditions
• None
Procedure
............................................................................................................................................................
1
Use OP:STATUS,GQPHLNK or examine the QGCON/5829 office
records to verify that connectivity exists between the desired new SIP
CP SM(s) and the SIP-T global SM/PSU.
............................................................................................................................................................
2
Select and prepare terminal for RC/V activities.
Provisioning
....................................................................................................................................................................................................................................
5-116
Lucent Technologies 235-200-118
Issue 3.02B, March 2007
To Next Page
Loading...
Need help?
General
