Lucent Technologies 5ESS - Add New SCTP Near Endpoint

Add New SCTP Near Endpoint
....................................................................................................................................................................................................................................
Purpose
This procedure defines the steps for adding a new SCTP near
endpoint.
When to use
Use this procedure to add a new SCTP near endpoint.
Related information
Refer to 235-118-258, Recent Change Reference, for information on
the RC/V system.
Refer to 235-080-100, Translations Guide, for information on Office
Records (output reports).
Refer to the 235-600-700/750, Input/Output Messages manuals for
additional information on the Input and Output commands.
Admonishments
None.
Before you begin
Required Tools
• Supplemental Trunk Line Workstation (STLWS) or Recent
Change and Verify (RC/V) terminal
• Access to RC/V Menu Interface
Required Material
• The 5ESS
®
switch must be running a 5E16.2 FR3 software
release with the SIP for Packet Trunking - NAR feature software.
Required Information
• IP Addresses of adjacent routers
Required Conditions
• None
Procedure
............................................................................................................................................................
1
Examine the PCRGRP/5883 and SCTPNEPD/5886 office records to
identify a processor group that does not have an SCTP near endpoint
assigned to it or execute the “Add New SIPT PHE2 IP Processor
Group on an Existing SIP GSM” (5-95) procedure.
Provisioning
....................................................................................................................................................................................................................................
235-200-118
Issue 3.02B, March 2007
Lucent Technologies
5-99