Delete All SCTP Association Protocol Parameter Sets (RC/V
33.20)
....................................................................................................................................................................................................................................
Purpose
The SCTP Association Parameter Set (RC/V 33.20) view is used to
update protocol parameters for an SCTP association.
When to use
This procedure should be followed to delete customer defined
association parameter sets.
Related information
Refer to 235-118-258, Recent Change Reference for information on
the RC/V system.
Refer to 235-080-100, Translations Guide, for information on Office
Records (output reports).
Refer to the 235-600-700/750, Input/Output Messages manuals for
additional information on the Input and Output commands.
Admonishments
None.
Before you begin
Required Tools
• Supplemental Trunk Line Workstation (STLWS) or Recent
Change and Verify (RC/V) terminal
• Access to RC/V Menu Interface
Required Material
• The 5ESS
®
switch must be running a 5E16.2 FR3 software
release or later with the SIP for Packet Trunking - NAR feature
software.
Required Information
• All SCTP Association Parameter set names.
Required Conditions
• All SCTP Associations have been deleted on RC/V 33.22
Procedure
............................................................................................................................................................
1
Dump the ASSCPARM/5887 office records. At the MCC or TLWS
type and enter the command:
OP:OFR:FORM=5887;
Deprovisioning
....................................................................................................................................................................................................................................
6-44
Lucent Technologies 235-200-118
Issue 3.02B, March 2007
To Next Page
Loading...
Need help?
General
