Insert SIP PSTN Interworking Parameter Set (RC/V 5.83)
....................................................................................................................................................................................................................................
Purpose
The SIP PSTN Interworking Parameter Set view (RC/V 5.83) is used
to define interworking between SIP and ISUP parameters. The new
view consists of two screens; one for PSTN to SIP interworking and a
second for mapping from SIP to PSTN.
When to use
Use this procedure to create a new SIP PSTN interworking parameter
set to use instead of the DEFAULT parameter sets. The DEFAULT
SIP PSTN interworking parameter sets, “DEFAULTISUP” and
“DEFAULTNOISUP”, are created when the first SIP GSM is inserted.
This procedure should also be used to modify individual parameter
values (within the allowable ranges for each parameter) that are
different (non-default) from the default value.
The RC/V view 5.71 uses the set name to associate it with a packet
group.
Related information
Refer to 235-118-258, Recent Change Reference, for information on
the RC/V system.
Admonishments
None.
Before you begin
Required Tools
• Supplemental Trunk Line Workstation (STLWS) or Recent
Change and Verify (RC/V) terminal
• Access to RC/V Menu Interface
Required Material
• The 5ESS
®
switch must be running on the 5E16.2 FR6 or later
software release with the SIP for Packet Trunking - NAR feature
software.
Required Information
• SIP PSTN interworking parameter set name
Required Conditions
• Secured Feature 684 is enabled (RC/V 8.22)
• SIP GSM is defined (RC/V 5.80)
Provisioning
....................................................................................................................................................................................................................................
5-74
Lucent Technologies 235-200-118
Issue 3.02B, March 2007
To Next Page
Loading...
Need help?
General
