Delete All SIP Parameter Sets (RC/V 5.82)
....................................................................................................................................................................................................................................
Purpose
The SIP-T Parameters Definition view (RC/V 5.82) is used to delete a
SIP parameter set for the packet trunking application.
When to use
Use this procedure to delete all SIP parameter set.
Related information
Refer to 235-118-258, Recent Change Reference for information on
the RC/V system.
Refer to 235-080-100, Translations Guide, for information on Office
Records (output reports).
Refer to the 235-600-700/750, Input/Output Messages manuals for
additional information on the Input and Output commands.
Admonishments
None.
Before you begin
Required Tools
• Supplemental Trunk Line Workstation (STLWS) or Recent
Change and Verify (RC/V) terminal
• Access to RC/V Menu Interface
Required Material
• The 5ESS
®
switch must be running a 5E16.2 FR3 software
release or later with the SIP for Packet Trunking - NAR feature
software.
Required Information
• None.
Required Conditions
• All SIP-T packet groups have been deleted on RC/V 5.71
Procedure
............................................................................................................................................................
1
Identify SIP parameter sets in the SIPTPARM/5882 office records. At
the MCC or TLWS type and enter the command:
OP:OFR:FORM=5882;
Result:
OP OFR FORM=5882 PF is printed followed by a printout
of the SIPTPARM/5882 office records.
Deprovisioning
....................................................................................................................................................................................................................................
6-78
Lucent Technologies 235-200-118
Issue 3.02B, March 2007
To Next Page
Loading...
