Lucent Technologies 5ESS - Delete All SCTP Endpoint Timers and Protocol Parameters; Delete All SCTP Endpoint Timers and Protocol Parameters (RC;V 33.18)

Delete All SCTP Endpoint Timers and Protocol Parameters
(RC/V 33.18)
....................................................................................................................................................................................................................................
Purpose
SCTP Endpoint Parameters (RC/V 33.18) is used to delete the SCTP
endpoint related timers and protocol parameters.
When to use
This procedure is used to delete all SCTP Endpoint parameter sets.
Related information
Refer to 235-118-258, Recent Change Reference for information on
the RC/V system.
Refer to 235-080-100, Translations Guide, for information on Office
Records (output reports).
Refer to the 235-600-700/750, Input/Output Messages manuals for
additional information on the Input and Output commands.
Admonishments
None.
Before you begin
Required Tools
• Supplemental Trunk Line Workstation (STLWS) or Recent
Change and Verify (RC/V) terminal
• Access to RC/V Menu Interface
Required Material
• The 5ESS
®
switch must be running a 5E16.2 FR3 software
release or later with the SIP for Packet Trunking - NAR feature
software.
Required Information
• All SCTP Endpoint Parameter Set Names.
Required Conditions
• All SCTP Near Endpoints have been deleted on RC/V 33.19
Procedure
............................................................................................................................................................
1
Dump the SCTPPARM/5885 office records. At the MCC or TLWS
type and enter the command:
OP:OFR:FORM=5885;
Deprovisioning
....................................................................................................................................................................................................................................
235-200-118
Issue 3.02B, March 2007
Lucent Technologies
6-47