EasyManuals Logo

Lucent Technologies 5ESS User Manual

Lucent Technologies 5ESS
552 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #168 background imageLoading...
Page #168 background image
Provisioning Sequences
....................................................................................................................................................................................................................................
Introduction
This section contains the startup procedures for provisioning SM
connectivity and SIP signaling. Figure 5-1, “SM Connectivity
Provisioning Flowchart” (5-3), Figure 5-2, “Signaling Provisioning
Flowchart for SIP with SCTP Transport” (5-5), and Figure 5-3,
“Signaling Provisioning Flowchart for SIP with UDP Transport” (5-7)
contain the steps that can be executed synchronously and
asynchronously. Each section contains example scenarios that can be
used for provisioning the SIP application.
Note: The SM connectivity provisioning does not apply to
DRM/VCDX.
In the flowcharts, the arrows indicate which RC/V views must be
provisioned before the next RC/V can be provisioned. For example, in
Figure 5-2, “Signaling Provisioning Flowchart for SIP with SCTP
Transport” (5-5) the boxes with arrows pointing to the box with
Association (RC/V 33.22) must be executed before the Association
(RC/V 33.22) can be executed. Therefore the SCTP Near Endpoint
(RC/V 33.19), and Far Endpoint (RC/V 33.21) views must be
executed before the Association (RC/V 33.22) view.
The following RC/V views are listed in each flowchart but are
executed only once. These views are listed in each flowchart to show
they must be provisioned before other views.
Secured Feature (RC/V 8.22)
SIP GSM (RC/V 5.80)
Equipment Subunit Protocol Handler (RC/V 22.4)
PSU Protocol Handler Channel Group Assignment (RC/V 22.16)
Some provisioning may already be complete prior to provisioning the
SIP application. For example the MH Pipe Assignment RC/V 17.20 is
executed only once when an SM-2000 is added to the network. This
procedure does not need to be executed if another SM-2000 is not
being added.
Provisioning SM
Connectivity
Figure 5-1, “SM Connectivity Provisioning Flowchart” (5-3) displays
the provisioning sequence for SM Connectivity.
Provisioning
....................................................................................................................................................................................................................................
5-2
Lucent Technologies 235-200-118
Issue 3.02B, March 2007

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Lucent Technologies 5ESS and is the answer not in the manual?

Lucent Technologies 5ESS Specifications

General IconGeneral
BrandLucent Technologies
Model5ESS
CategorySwitch
LanguageEnglish

Related product manuals