Insert Processor Group (RC/V 33.16)
....................................................................................................................................................................................................................................
Purpose
The Processor Group view (RC/V 33.16) defines a processor group. A
processor group identifies one or two SIP PHs. If two SIP PHs
operate as a pair with serving and non-serving roles, the serving and
non-serving roles are chosen dynamically.
When to use
Use this procedure to define a new processor group.
Repeat individual steps of this procedure as required.
Related information
Refer to 235-118-258, Recent Change Reference, for information on
the RC/V system.
Admonishments
None.
Before you begin
Required Tools
• Supplemental Trunk Line Workstation (STLWS) or Recent
Change and Verify (RC/V) terminal
• Access to RC/V Menu Interface
Required Material
• The 5ESS
®
switch must be running a 5E16.2 FR3 software
release with the SIP for Packet Trunking - NAR feature software.
Required Information
• Processor Group Number - identifies a processor group
• SM - identifies SM where a processor group is located
• Application type - identifies the type of processor group
• PSU number - identifies the PSU2
• PM Group - identifies a performance monitoring group
• PH information
- PSU shelf - identifies PSU2 shelf
- Channel group - identifies PH’s Channel Group on the shelf
- Position - identifies physical slot of PH on the shelf that is
defined by a hardware procedure
- PHE link - identifies a link number to a PHE2
Provisioning
....................................................................................................................................................................................................................................
5-38
Lucent Technologies 235-200-118
Issue 3.02B, March 2007
To Next Page
Loading...
Need help?
General
