Assign PH Channel Group as IP Processor (RC/V 33.1)
....................................................................................................................................................................................................................................
Purpose
The Internet Protocol (IP) Processor Assignment view (RC/V 33.1)
assigns IP addresses and parameters to a processor (PHE2).
When to use
Use this procedure to define IP parameters on a processor.
Repeat individual steps of this procedure as required.
Related information
Refer to 235-118-258, Recent Change Reference, for information on
the RC/V system.
Admonishments
None.
Before you begin
Required Tools
• Supplemental Trunk Line Workstation (STLWS) or Recent
Change and Verify (RC/V) terminal
• Access to RC/V Menu Interface
Required Material
• The 5ESS
®
switch must be running a 5E16.2 FR3 software
release with the SIP for Packet Trunking - NAR feature software.
Required Information
• Processor ID
• Processor type
• Shelf number
• Channel Group number
• Local IP address
• IP subnet mask
Required Conditions
• Protocol Handler is defined (RC/V 22.4)
• Channel Group is defined (RC/V 22.16)
Procedure
............................................................................................................................................................
1
Select and prepare terminal for RC/V activities.
Reference:
“Select and Prepare Terminal” (5-11)
Provisioning
....................................................................................................................................................................................................................................
5-34
Lucent Technologies 235-200-118
Issue 3.02B, March 2007
To Next Page
