Remove SCTP Near Endpoint
....................................................................................................................................................................................................................................
Purpose
This procedure requests the removal of an SCTP Near Endpoint.
When to use
Use this procedure when the removal of an SCTP Near Endpoint is
required.
Related information
Refer to the Input Messages Manual, 235-600-700, and the Output
Messages Manual, 235-600-750,for additional information.
Admonishments
Unconditionally removing an endpoint can be service-affecting
causing the shutdown of traffic.
Before you begin
Required Tools
• Use of the Master Control Center (MCC) or Supplementary
Trunk Line Workstation (STLWS).
Required Material
• The switch must be running a 5E16.2 FR3 software release or
later with the SIP for Packet Trunking feature software.
Required Information
• Near endpoint name to be removed is known.
Required Conditions
• Endpoint status is not already NOSERV or OOS.
Procedure
............................................................................................................................................................
1
Request a removal of a specific near endpoint:
RMV:SCTP,NEAREPT=a,[UCL];
Where:
a = near endpoint name
Result:
Reports the result of removing a specific near endpoint from
service.
Maintenance Considerations
....................................................................................................................................................................................................................................
235-200-118
Issue 3.02B, March 2007
Lucent Technologies
7-75
To Next Page
Loading...
Need help?
General
