Delete SCTP Near Endpoint
....................................................................................................................................................................................................................................
Purpose
This section contains the procedures for deleting an SCTP near
endpoint.
When to use
Use this procedure to delete an SCTP near endpoint
Related information
Refer to 235-118-258, Recent Change Reference for information on
the RC/V system.
Admonishments
None.
Before you begin
Required Tools
• Supplemental Trunk Line Workstation (STLWS) or Recent
Change and Verify (RC/V) terminal
• Access to RC/V Menu Interface
Required Material
• The 5ESS
®
switch must be running a 5E16.2 FR3 software
release or later with the SIP for Packet Trunking - NAR feature
software.
Required Information
• SCTP Near Endpoint name
Required Conditions
• No SCTP associations provisioned on endpoint, endpoint in
GROW STATE
Procedure
............................................................................................................................................................
1
Select and prepare terminal for RC/V activities.
Reference:
“Select and Prepare Terminal” (5-11)
............................................................................................................................................................
2
Delete the SCTP near endpoint for the processor group using the
procedure “Delete All SCTP Near Endpoints (RC/V 33.19)” (6-41).
This procedure can be used to delete all SCTP Near Endpoints, or in
this case, to delete an individual SCTP Near Endpoint.
Deprovisioning
....................................................................................................................................................................................................................................
235-200-118
Issue 3.02B, March 2007
Lucent Technologies
6-107
To Next Page
Loading...
Need help?
General
