Change SCTP Association Parameters
....................................................................................................................................................................................................................................
Purpose
This section contains the procedure for changing the SCTP association
parameters.
When to use
Use this procedure to change the SCTP association parameters.
Related information
Refer to 235-118-258, Recent Change Reference, for information on
the RC/V system.
Refer to 235-080-100, Translations Guide, for information on Office
Records (output reports).
Refer to the 235-600-700/750, Input/Output Messages manuals for
additional information on the Input and Output commands.
Admonishments
None.
Before you begin
Required Tools
• Supplemental Trunk Line Workstation (STLWS) or Recent
Change and Verify (RC/V) terminal
• Access to RC/V Menu Interface
Required Material
• The 5ESS
®
switch must be running a 5E16.2 FR3 software
release or later with the SIP for Packet Trunking - NAR feature
software.
Required Information
• SCTP Association parameter set name
Required Conditions
• None
Procedure
............................................................................................................................................................
1
All associations that use the parameter set to be updated, must be
CLOSED MAN before the update can be made.
Examine the SCTPASSC/5889 office records to find all the
associations that reference the association parameter set to be updated,
and use RMV:SCTP,ASSOC to put them all in the CLOSED MAN
Provisioning
....................................................................................................................................................................................................................................
5-144
Lucent Technologies 235-200-118
Issue 3.02B, March 2007
To Next Page
Loading...
