Change IP/SCTP Transport Address for SCTP Far Endpoint
....................................................................................................................................................................................................................................
Purpose
This section contains the procedure for changing the IP/SCTP
transport address for an SCTP far endpoint.
When to use
Use this procedure to change the IP/SCTP transport address for an
SCTP far endpoint.
Related information
Refer to 235-118-258, Recent Change Reference, for information on
the RC/V system.
Refer to the 235-600-700/750, Input/Output Messages manuals for
additional information on the Input and Output commands.
Admonishments
None.
Before you begin
Required Tools
• Supplemental Trunk Line Workstation (STLWS) or Recent
Change and Verify (RC/V) terminal
• Access to RC/V Menu Interface
Required Material
• The 5ESS
®
switch must be running a 5E16.2 FR3 software
release with the SIP for Packet Trunking - NAR feature software.
Required Information
• Far Endpoint name
• New IP address(es)
Required Conditions
• Use OP:STATUS,SCTP,ASSOC,ALL to verify that the SCTP
associations to the affected far endpoint (from all SCTP near
endpoints, on all SIP-T GSMs) are in the CLOSED MAN state.
If they are not, use the procedure to put them in the CLOSED
MAN state.
Procedure
............................................................................................................................................................
1
Select and prepare terminal for RC/V activities.
Reference:
“Select and Prepare Terminal” (5-11)
Provisioning
....................................................................................................................................................................................................................................
5-126
Lucent Technologies 235-200-118
Issue 3.02B, March 2007
To Next Page
Loading...
