Delete Existing SCTP Association to SCTP Far Endpoint
....................................................................................................................................................................................................................................
Purpose
This section contains the procedure for deleting existing SCTP
associations to SCTP far endpoints.
When to use
Use this procedure to delete an existing SCTP association to an SCTP
far endpoint.
Related information
Refer to 235-118-258, Recent Change Reference for information on
the RC/V system.
Refer to 235-080-100, Translations Guide, for information on Office
Records (output reports).
Refer to the 235-600-700/750, Input/Output Messages manuals for
additional information on the Input and Output commands.
Admonishments
None.
Before you begin
Required Tools
• Supplemental Trunk Line Workstation (STLWS) or Recent
Change and Verify (RC/V) terminal
• Access to RC/V Menu Interface
Required Material
• The 5ESS
®
switch must be running a 5E16.2 FR3 software
release or later with the SIP for Packet Trunking - NAR feature
software.
Required Information
• Association number
Required Conditions
• None
Procedure
............................................................................................................................................................
1
Select and prepare terminal for RC/V activities.
Reference:
“Select and Prepare Terminal” (5-11)
Deprovisioning
....................................................................................................................................................................................................................................
235-200-118
Issue 3.02B, March 2007
Lucent Technologies
6-101
To Next Page
Loading...
Need help?
General
