Lucent Technologies 5ESS - Delete SIP PHE2 from Existing Duplex SIP IP Processor Group

Delete SIP PHE2 from Existing Duplex SIP IP Processor Group
....................................................................................................................................................................................................................................
Purpose
This procedure is used to delete a SIP PHE2 from an existing duplex
SIP IP processor group.
When to use
Use this procedure to delete a SIP PHE2 from an existing duplex SIP
IP processor group.
Related information
Refer to 235-118-258, Recent Change Reference for information on
the RC/V system.
Refer to 235-105-331, Hardware Change Procedures - Degrowth for
information on degrowth of the PHE2.
Refer to the 235-600-700/750, Input/Output Messages manuals for
additional information on the Input and Output commands.
Admonishments
None.
Before you begin
Required Tools
• Supplemental Trunk Line Workstation (STLWS) or Recent
Change and Verify (RC/V) terminal
• Access to RC/V Menu Interface
Required Material
• The 5ESS
®
switch must be running a 5E16.2 FR3 software
release or later with the SIP for Packet Trunking - NAR feature
software.
Required Information
• SM, PSU, and PCR GRP (RC/V 33.16).
• Shelf and CHGRP of PHE2 to be removed from the SIP IP
Processor group.
Required Conditions
• None
Procedure
............................................................................................................................................................
1
Use the OP:STATUS,SERV command to determine whether the PHE2
to be deleted is currently the SERVING PH in the SIP-T processor
Deprovisioning
....................................................................................................................................................................................................................................
235-200-118
Issue 3.02B, March 2007
Lucent Technologies
6-89