Result:
Generates the service selection switch report for a specific
PSU2.
............................................................................................................................................................
2
Check results and take appropriate action:
• If the switch
FAILED, then probably a software error occurred.
SEEK TECHNICAL ASSISTANCE according to local procedures
for the affected PH.
• If the switch is
DENIED, then a wrong identifier was entered.
Retry with the correct identifier.
• If the response is
ELNK DOWN, then determine the cause of the
Ethernet link going down and repair it, if possible.
• If the response is
PING FAILURE, then the problem is most likely
with the adjacent IP router external to the 5ESS
®
switch.
............................................................................................................................................................
3
Stop. You have completed this procedure.
Request Manual Service Selection Switch
Maintenance Considerations
....................................................................................................................................................................................................................................
7-84
Lucent Technologies 235-200-118
Issue 3.02B, March 2007
E ND OF S TEPS
.........................................................................................................................................................................................................................................................
To Next Page
Loading...
