Required Conditions
• Processor Group is defined (RC/V 33.16)
• Ethernet IP interface is defined (RC/V 33.4)
• IP routing exists for far-end IP address (RC/V 33.3), if far-end IP
address is not in the same subnet as GATEWAY IP ADDR1 of
the Ethernet/IP interface (RC/V 33.4)
Procedure
............................................................................................................................................................
1
Select and prepare terminal for RC/V activities.
Reference:
“Select and Prepare Terminal” (5-11)
............................................................................................................................................................
2
Type and enter the RC/V form number.
33.24
Result:
Enter Database Operation I=Insert,R=Review,U=Update,
D=Delete:
............................................................................................................................................................
3
Type and enter the insert command.
I
Result:
The UDP Path page is displayed.
............................................................................................................................................................
4
Using the RC/V 33.24 form as a guide, type and enter the parameters.
• UDP Path number
• GSM number
• PSU number (0)
• Processor Group number
• Near-end UDP port
• Far-end IP address
• Far-end UDP port
............................................................................................................................................................
5
Enter the insert command.
I
Insert UDP Path (RC/V 33.24)
Provisioning
....................................................................................................................................................................................................................................
235-200-118
Issue 3.02B, March 2007
Lucent Technologies
5-51
To Next Page
