Reference:
“ Insert SCTP Association Set (RC/V 33.23)” (5-68)
............................................................................................................................................................
3
At the MCC or TLWS type and enter the backup command.
BKUP:ODD;
Result:
BKUP ODD COMPLETED
............................................................................................................................................................
4
Verify that equivalent provisioning of the association has been done at
the far endpoint.
............................................................................................................................................................
5
Use RST:SCTP,ASSOC to restore the association and
OP:STATUS,SCTP,ASSOC to verify that it becomes ESTABLISHED.
............................................................................................................................................................
6
Stop. You have completed this procedure.
Add SCTP Associations to Existing
Association Set
Provisioning
....................................................................................................................................................................................................................................
5-108
Lucent Technologies 235-200-118
Issue 3.02B, March 2007
E ND OF S TEPS
.........................................................................................................................................................................................................................................................
To Next Page
Loading...
