• When UDP transport is used, identify the IP addresses and UDP
ports on the other SIP-enabled switches in the network to which
the 5ESS
®
switch will be connecting SIP calls. UDP transport
supports only one IP address at each end.
• Verify that sufficient PH hardware is available to install in the
global PSU2 and for replacement boards. The absolute minimum
is two TN13 packs with LLE2 100BaseT Ethernet paddleboards
and three TN113 packs with no paddleboards.
Note:All the above recommendations for selecting SMs don’t apply to
DRM/VCDX, since there is only the one SM.
Disclaimer
IP management is the customer’s responsibility.
Provisioning Sequences
Provisioning
....................................................................................................................................................................................................................................
5-10
Lucent Technologies 235-200-118
Issue 3.02B, March 2007
To Next Page
Loading...
Need help?
General
