............................................................................................................................................................
3
Type and enter the review command.
R
Result:
The CCS OFFICE PARAMETERS page is displayed and the
cursor is located at the OFFICE ID field.
............................................................................................................................................................
4
Proceed to screen 2.
2
Result:
Screen 2 is displayed and the cursor is located at the bottom of
Screen 2.
............................................................................................................................................................
5
Verify that the *COUNTRY CODE field is set to 1.
NOTE: If it is not set to 1, enter the Update mode and type 1 in the
*COUNTRY CODE field.
............................................................................................................................................................
6
Proceed to screen X.
X
Result:
Screen X is displayed and the cursor is located at the bottom of
Screen X.
............................................................................................................................................................
7
Specify the NATIONAL CIRCUIT CODE field.
............................................................................................................................................................
8
Enter the update command.
U
Result:
Updating...form updated
............................................................................................................................................................
9
Type and enter the previous screen command.
<
Update CCS Office Parameters (RC/V 8.15)
Provisioning
....................................................................................................................................................................................................................................
5-72
Lucent Technologies 235-200-118
Issue 3.02B, March 2007