............................................................................................................................................................
9
If desired, type and enter the quit command to exit the RC/V system.
Q
Result:
The RC/V session is terminated.
............................................................................................................................................................
10
If associations were CLOSED MAN in order to update the
parameters, use RST:SCTP,ASSOC to establish them again.
............................................................................................................................................................
11
At the MCC or TLWS type and enter the backup command.
BKUP:ODD;
Result:
BKUP ODD COMPLETED
............................................................................................................................................................
12
Stop. You have completed this procedure.
Change SCTP Association Parameters
Provisioning
....................................................................................................................................................................................................................................
5-146
Lucent Technologies 235-200-118
Issue 3.02B, March 2007
E ND OF S TEPS
.........................................................................................................................................................................................................................................................
To Next Page
Loading...
