Result:
Check the results and take one of the following actions:
• If
neither of the QLPSes is ACT, then at least one of the
QLPSes must be recovered. EXIT this procedure and refer
to the Corrective Maintenance procedure, Clear Quad Link
Packet Switch Problems, 235-105-220, to repair the QLPS.
After the QLPS is recovered, RE-ENTER this procedure at
Step 1.
• If only one QLPS is
ACT in network d but one or more
child
QTMSLNKs is OOS, then request a detailed status of
the GQPH QPipe:
OP:STATUS,GQPHPIPE,QPIPE=a-b-c-d-e,DETAIL;
Where:
a = Global switch module number
b = Packet switch unit 2 number
c = PSU2 shelf number
d = GQPH channel group number
e = QLPS network number
If the QTMSLNK port in the output matches an
OOS
QTMSLNK
on the target ACT QLPS, then EXIT this
procedure and refer to the Corrective Maintenance
procedure, Correct QTMSLNK Problems, 235-105-220, to
repair the QTMSLNK. After the link is recovered,
RE-ENTER this procedure at Step 1.
• If one QLPS is
ACT in network d and no child QTMSLNK
is OOS, then request a detailed status of the GQPH QPIPE:
OP:STATUS,GQPHPIPE,QPIPE=a-b-c-d-e,DETAIL;
Where:
a = Global switch module number
b = Packet switch unit 2 number
c = PSU2 shelf number
d = GQPH channel group number
e = QLPS network number
The corresponding primary network link interface (NLI)
serving the
ACT QLPS on QLPS network d is specified in
the output. Only a single digit
j (0 or 1) is specified and
actually
NLI a-j-k, where k is the ONTC with the active
QLPS, is serving the target GQPH QPipe.
Access the NLI Summary page:
1200,X
Resolve GQPH QPipe Problems
Maintenance Considerations
....................................................................................................................................................................................................................................
235-200-118
Issue 3.02B, March 2007
Lucent Technologies
7-47
To Next Page
Loading...
Need help?
General
