Lust MASTERCONTROL MC6000 Series User Manual

_CONF – Device configuration and I/O Subject area • 13Parameter Description MC6000/7000
_ENCD
_VAL
Index
_VFCON
_PMOD
_KPAD
Contents
Introduction
_SIO
_SCTY
_REF
_SYS
_IO1
_IO2
_CAN
_OPT1
_MOT
_CONF
_TCON
_SCON
_PCON
488-BUSYE - Activate/deactivate synchronization
Source:
Function: Parameter for future application, currently without function.
With this parameter synchronization of the drive is activated.
0 = no synchronization)
486-BUTCD - Max. permissible cycle deviation relative to master
Source: Bus Time Cycle
Function: Parameter only for CAN bus.
Maximum permissible deviation of the internal cycle relative to the cycle of drive 1.
Scaling: 1 bit = 0.1 µs.
487-BUTCS - Sampling time of status message relative to "BUTCY"
Source: Bus Time Cycle to Status
Function: Parameter only for CAN bus.
Sampling time of status message relative to bus cycle time BUTCY
The status message is delivered: 1 = every cycle; 2 = every 2nd cycle; etc.
411-BUTCY - Bus sampling time in microseconds
Source: Bus Time Cycle
Function: Parameter only for CAN bus.
Sampling time of the CAN bus in microseconds.
Scaling: 1 bit = 1 µs.
Values:
Minimum Maximum Factory set. Unit MODE SMARTCARD Type
OFF ON OFF – R3W3 SYSTM USIGN8
Values:
Minimum Maximum Factory set. Unit MODE SMARTCARD Type
OFF ON OFF – R3W3 SYSTM USIGN16
Values:
Minimum Maximum Factory set. Unit MODE SMARTCARD Type
1 255 10 – R3W3 SYSTM USIGN8
Values:
Minimum Maximum Factory set. Unit MODE SMARTCARD Type
100 32000 1000 – R3W3 SYSTM USIGN16
Note:
This parameter only need be set if time-equidistant adoption of the reference value is
required.
Í 487-BUTCS - Sampling time of status message relative to "BUTCY"
, Page 13

Lust MASTERCONTROL MC6000 Series Specifications

General

Brand	Lust
Model	MASTERCONTROL MC6000 Series
Category	Controller
Language	English