Lust MASTERCONTROL MC6000 Series User Manual

94 • Subject area _SYS – Diagnosis and digital scope Parameter Description MC6000/7000
_ENCD
_VAL
Index
_VFCON
_PMOD
_KPAD
Contents
Introduction
_SIO
_SCTY
_REF
_SYS
_IO1
_IO2
_CAN
_OPT1
_MOT
_CONF
_TCON
_SCON
_PCON
31-PTR_H, 30-PTR_L - Data pointer to any memory locations
Source: Pointer High Word, Pointer Low Word
Function: High word, Low word of the data pointer which addresses a memory location. With P-VAL
this memory location can be read and written.
32-P-VAL - Editable memory location of data pointer
Source:
Function: The parameter reads from and writes to the memory location addressed with PTR_H,
PTR_L.
111-VPROG - Capacity utilization of VECON program memory
Source:
Function: Only for display of the percentage capacity utilization of the VeCon program memory.
At >100% E-VEC is signaled.
CAUTION - Do not change parameter!
Parameter only for development and service purposes
Values:
Minimum Maximum Factory set. Unit MODE SMARTCARD Type
0000H FFFFH – R6W6 ALL USIGN16
CAUTION - Do not change parameter!
Parameter only for development and service purposes
Values:
Minimum Maximum Factory set. Unit MODE SMARTCARD Type
0000 FFFFH 0000H – R6W6 ALL USIGN16
Values:
Minimum Maximum Factory set. Unit MODE SMARTCARD Type
0000H FFFFH 0000H % R6W6 ALL USIGN16

Lust MASTERCONTROL MC6000 Series Specifications

General

Brand	Lust
Model	MASTERCONTROL MC6000 Series
Category	Controller
Language	English