_SIO – Serial interface RS485 Subject area • 77Parameter Description MC6000/7000
_ENCD
_VAL
Index
_VFCON
_PMOD
_KPAD
Contents
Introduction
_SIO
_SCTY
_REF
_SYS
_IO1
_IO2
_CAN
_OPT1
_MOT
_CONF
_TCON
_SCON
_PCON
107-UNIT - Available parameter units
Source:
Function: Calls off the units of the parameters (by way of value substitution texts) over the bus
system.
108-STEXT - Handshake parameter for transfer of value substitution texts
Source:
Function: STEXT gives the setting no. of a parameter. The corresponding value substitution text is
returned. (The parameter number is defined in the protocol.)
CAUTION - Do not change parameter!
Parameter only for development and service purposes
Values:
Minimum Maximum Factory set. Unit MODE SMARTCARD Type
kgmm – R5W5 ALL USIGN8
CAUTION - Do not change parameter!
Parameter only for development and service purposes
Values:
Minimum Maximum Factory set. Unit MODE SMARTCARD Type
0 999 0 – R5W5 ALL USIGN16
To Next Page
Loading...
Need help?
General