MacDon FlexDraper FD75 - Adjusting Auto Reel Speed - CLAAS 500 Series; Adjusting Auto Reel Speed - CLAAS 600 and 700 Series

214323 185 Revision B
1003736
A
B
Figure 4.114: CLAAS Combine Display, Console, and
Joystick
1. Use control knob (A) to highlight HEADER/REEL icon (B) and
press control knob (A) to select it. The HEADER/REEL dialog
box appears.
2. Select the HEADER icon.
1003737
A
B
Figure 4.115: CLAAS Combine Display, Console, and
Joystick
3. Select FRONT ATTACHMENT PARAMETER SETTINGS
icon (A). A list of settings appears.
4. Select SENSITIVITY CAC (B) from the list.
1009743
A
B
Figure 4.116: CLAAS Combine Display, Console, and
Joystick
5. Select SENSITIVITY CAC icon (A).
NOTE:
To set the sensitivity, you will have to change CUTTING
HEIGHT ADJUSTMENT (B) from its default value of 0.
Settings from 1–50 provide a faster header height
adjustment, whereas settings from -1 to -50 provide a
slower header height adjustment. For best results, make
the adjustments by increments of five.
6. If the reaction time between the header and the adapter is
too slow while cutting on ground, increase CUTTING
HEIGHT ADJUSTMENT setting (B). If the reaction time
between the header and the adapter is too fast, decrease
CUTTING HEIGHT ADJUSTMENT setting (B).
7. Increase the sensitivity if the header falls too slowly.
Decrease the sensitivity if the header hits the ground too
hard or falls too quickly.
AUTO HEADER HEIGHT CONTROL