MacDon FlexDraper FD75 - Adjusting Header Raise Rate - New Holland CR;CX Series; Setting Header Lower Rate - New Holland CR;CX Series

214323 271 Revision B
4.19.4 Adjusting Header Raise Rate – New Holland CR/CX Series
The speed at which the header rises on a New Holland CR or CX Series combine can be adjusted from the combine cab.
NOTE:
Changes may have been made to the combine controls or the display since this document was published. Refer to the
combine operator’s manual for updated information.
1003628
Figure 4.289: New Holland Combine Display
1. Select HEADER RAISE RATE on the combine display.
2. Use the + or – buttons to change the value.
3. Press ENTER to save the new setting.
NOTE:
The raise rate can be changed from 32 to 236 in increments
of 34. The factory setting is 100.
4.19.5 Setting Header Lower Rate – New Holland CR/CX Series
The speed at which the header falls on a New Holland CR or CX Series combine can be adjusted from the combine cab. The
recommended header lower rate for these combines is 50.
NOTE:
Changes may have been made to the combine controls or the display since this document was published. Refer to the
combine operator’s manual for updated information.
1003628
Figure 4.290: New Holland Combine Display
1. Select HEADER LOWER RATE on the combine display.
2. Use + or – buttons to change setting to 50.
3. Press ENTER to save the new setting.
NOTE:
The header lower rate can be changed from 2 to 247 in
increments of 7. It is factory-set to 100.
AUTO HEADER HEIGHT CONTROL