MacDon FlexDraper FD75 - Installing Side Draper Drive Roller; Side Draper Idler Roller; Removing Side Draper Idler Roller

214323 437 Revision B
Installing Adapter Feed Draper Idler Roller
1003003
A
B
C
Figure 6.176: Idler Roller
1. Position idler roller assembly (B) in the feed deck.
2. Install two bolts (A) and nuts (C) at both ends of the
idler roller.
1014024
A
B
Figure 6.177: Draper Connector
3. Close the feed draper and secure with connector straps (B),
screws (A), and nuts.
4. Tension the feed draper. For instructions, refer to 6.10.2
Checking and Adjusting Feed Draper Tension, page 429.
5. Attach the header to the adapter. For instructions, refer to
5.7.2 Attaching Header to Adapter and Combine, page 335.
6.10.5 Lowering Polyethylene Door – Adapter Feed Deck
DANGER
To prevent bodily injury or death from the unexpected start-up or fall of a raised machine, always stop the engine and
remove the key before leaving the operator’s seat, and always engage the safety props before going under the
machine for any reason.
DANGER
Ensure that all bystanders have cleared the area.
1. Start the combine.
2. Raise the header fully, and engage the header lift cylinder locks.
3. Stop the engine, and remove the key from the ignition.
4. Engage the reel safety locks. For instructions, refer to Engaging Reel Safety Props, page 31.
MAINTENANCE AND SERVICING