MacDon FlexDraper FD75 - Adapter Idler Roller; Removing Adapter Feed Draper Idler Roller

214323 434 Revision B
Installing Adapter Feed Draper Drive Roller Bearing
1002992
A
B
C
Figure 6.168: Bearing
1. Install bearing flanges (C) and the bearing.
2. Install three bolts and nuts (B) to secure the bearing and
flanges (C) to the feed deck.
3. Lock bearing collar (A) and tighten the set screw.
4. Tension the feed draper. For instructions, refer to 6.10.2
Checking and Adjusting Feed Draper Tension, page 429.
5. Attach the header to the adapter. For instructions, refer to
5.7.2 Attaching Header to Adapter and Combine, page 335.
6.10.4 Adapter Idler Roller
Removing Adapter Feed Draper Idler Roller
DANGER
Engage the header safety props and reel props before working under the header or reel.
1. Remove the header from the adapter, but leave the adapter attached to the combine. Refer to 5.7.1 Detaching Header
from Adapter and Combine, page 330.
2. Engage the feeder house safety props.
1005638
A
B
C
Figure 6.169: Tensioner
3. Loosen jam nut (A) and hold nut (B) with a wrench while
turning bolt (C) counterclockwise to release the draper
tension. Repeat at the opposite side.
MAINTENANCE AND SERVICING