214323 497 Revision B
Installing Reel Drive Motor
The reel drive motor does not require regular maintenance or servicing. If problems occur with the motor, remove it and
have it serviced at your MacDon Dealer.
Figure 6.306: Reel Drive Motor Mounting Holes
1. Slide motor mount (A) up or down so motor mounting
holes (B) are accessible through the openings in the
chain case.
Figure 6.307: Reel Drive Motor
2. Attach motor (A) (and spacer if previously removed) to
motor mount (B) with four 1/2 in. x 1 3/4 in. countersunk
bolts and nuts (C).
3. Torque nuts (C) to 73 Nm (54 lbf∙ft).
4. If installing a new motor, install the hydraulic fittings (not
shown) and torque them to 110–120 Nm (81–89 lbf·ft).
Figure 6.308: Reel Motor and Hoses
5. Remove the caps or plugs from the ports and lines, and
connect hydraulic lines (A) to hydraulic fittings (B) on
motor (C).
NOTE:
Ensure hydraulic lines (A) are installed at their original
locations.
6. Install the drive sprocket. For instructions, refer to Installing
Reel Drive Sprocket, page 493.
7. Tighten the drive chain. For instructions, refer to Tightening
Reel Drive Chain, page 490.
MAINTENANCE AND SERVICING
To Next Page
Loading...
