MacDon FlexDraper FD75 - Adjusting Manual Header Raise;Lower Rate - John Deere 70 Series

214323 238 Revision B
1003636
A
B
C
Figure 4.213: John Deere Combine Control Console
1. Press button (A) twice. The current sensitivity setting will
appear on the combine display.
NOTE:
The lower the sensitivity value displayed, the lower the
sensitivity setting is. Higher sensitivity settings will change
how quickly the AHHC system changes the height of the
header.
2. Use scroll knob (B) to adjust the sensitivity setting. The
adjustment will be saved automatically.
NOTE:
If the page remains idle for a short period of time, it will
automatically return to the previous page. Pressing check
mark button (C) will also display the previous page.
1003637
Figure 4.214: John Deere Combine Display
NOTE:
The numbers depicted on the displays in these illustrations
are for reference purposes only; they are not intended to
represent specific settings for your equipment.
4.16.5 Adjusting Manual Header Raise/Lower Rate – John Deere 70 Series
The speed at which the header rises or falls on a John Deere 70 Series combine can be adjusted from the combine cab.
NOTE:
Changes may have been made to the combine controls or the display since this document was published. Refer to the
combine operator’s manual for updated information.
AUTO HEADER HEIGHT CONTROL