214323 499 Revision B
Figure 6.311: U-Joint
8. Position right reel tube (A) against the reel drive and
engage the stub shaft into the U-joint pilot hole.
9. Rotate the reel until the holes in end of the reel tube and
U-joint flange line up.
10. Apply medium-strength threadlocker (Loctite
®
243 or
equivalent) to four 1/2 in. bolts (A) and secure it with lock
washers.
11. Torque the bolts to 102–115 Nm (75–85 lbf∙ft).
Figure 6.312: Supporting Reel
12. Remove temporary reel support (A).
6.14.7 Replacing Reel Speed Sensor
The reel speed sensor system is located inside the reel drive cover.
Replacing AGCO Sensor
DANGER
To prevent bodily injury or death from the unexpected start-up or fall of a raised machine, always stop the engine,
remove the key, and engage the safety props before going under the header for any reason.
1. Shut down the combine, and remove the key from the ignition.
2. Remove the drive cover. Refer to Removing Reel Drive Cover, page 488.
MAINTENANCE AND SERVICING
To Next Page
Loading...
