Mitutoyo SJ-210 - Setting Calibration Conditions

6. CALIBRATION
No. 99MBB122A
6-13
6.5 Setting Calibration Conditions
Set the following calibration conditions according to the precision roughness specimen.
IMPORTANT
• The default values of the calibration conditions are in accordance with Mitutoyo's
precision roughness specimen. Unless otherwise required, perform calibration
measurement with the default conditions.
 Number of measurements per charge
 Roughness standard
 Filters
 Cut-off value (λc)
 Number of sampling lengths (N), or evaluation length (arbitrary length)
 Traversal speed
 Measurement range
Calibration measurement settings are specified on the Calibration Condition Setup screen.
NOTE
• To reset the calibration conditions collectively to the default values (factory settings),
press the “Initial” ([Red] key) on the Calibration Condition Setup screen.