Mitutoyo SJ-210 - ΔC (JIS2001, ISO1997, VDA, Free), Htp (ANSI): Slice-Level Difference (Plateau Ratio); Tp (ANSI): Material-Ratio Length Rate; Htp (ANSI): Slice-Level Difference (Plateau Ratio)

18. Reference Information
No.99MBB122A
18-33
18.5.23 δc (JIS2001, ISO1997, VDA, Free), Htp (ANSI): Slice-level difference (plateau
ratio)
With the slice level that is set from the mr[c] value as the reference line, δc is the height (or
depth), in m, from the reference line to slice levels obtained from changing the value of
mr[c]. When the slice level used to obtain the height (or depth) is higher than the reference
line, the value of δc is negative. When the slice level used to obtain the height (or depth) is
lower than the reference line, the value of δc is positive.
δc slice-level difference
18.5.24 tp (ANSI): Material-ratio length rate
Refer to 18.5.22, “mr[c] (ISO1997, JIS1994, 2001, VDA, Free), tp (ANSI): Material-ratio
length rate”.
18.5.25 Htp (ANSI): Slice-level difference (plateau ratio)
Refer to 18.5.23, “δc (JIS2001, ISO1997, VDA, Free), Htp (ANSI): Slice-level difference
(plateau ratio)”.
Reference line
X

m