Mitutoyo SJ-210 - Calculation Results

16. TROUBLESHOOTING
No. 99MBB122A
16-3
16.3 Calculation Results
■ Calculation results
Symptom/Error
display
Possible causes Remedies
Abnormal calibration
value!
The result of calibration measurement exceeds
the possible range of calibration.
Check the value of the precision roughness
specimen and the inputted nominal value.
Also, check the calibration measurement setup
conditions.
L 3,000 um Measurement result under a condition of
insufficient number of peaks and valleys.
E 0110 Parameter can not be calculated due to
insufficient number of peaks and valleys.
E 0116 Equivalent line can not be calculated.
E 0117 Roughness motif can not be calculated as more
than 2 local peaks which have required height do
not exist.
E 0118 The first roughness motif exceeds upper limit of
the length A.
E 0121 Parameter can not be calculated as more than 3
motifs do not exist.
Detector is not properly connected to the drive
unit.
Properly connect the detector to the drive unit.
Connecting cable between drive unit and display
unit is not properly connected.
Properly connect the drive unit to the display unit.
Calibration measurement was not performed
correctly due to improper setup of the SJ-210.
Re-calibrate the SJ-210.
Calculation result is
abnormal.
(Value is large/Value is
small/Value remain the
same irrespective of
workpiece.)
Stylus is worn.
Or other than the above.
Contact your dealer or the nearest Mitutoyo sales
office.
The GO/NG Judgment parameter has not been
set.
Select desired parameter for setting the GO/NG
Judgment.
Refer to 8.3, “Setting the GO/NG Judgment
Function”.
The GO/NG Judgment
result indicator does not
appear.
Upper limit/lower limit is set to minimum. Set the upper limit or lower limit.
Refer to 8.3, “Setting the GO/NG Judgment
Function”.