No. 99MBB122A
16-2
16.2 Measuring Operation
■ Measuring operation
Symptom/Error
display
Possible causes Remedies
Over-range error! The result exceeds the measurement range.
Properly connect the detector to the drive unit.
When a red light flashes in upper display, an
over-range error occurs.
When the measurement range has been fixed, set it
to Auto.
Aborting! The [START/STOP] key is pressed during
measurement is performed.
Perform measurement again.
No measurement is
performed right after the
[START/STOP] key is
pressed.
Self-timer function has been set to ON. Set the self-timer function to OFF.
Refer to 10.12, “Setting the Self-timer”.
To Next Page
Loading...
