Mitutoyo SJ-210 - MEASUREMENT RESULTS (LOAD;SAVE;DELETE;RENAME)

No. 99MBB122A

9-1
9 MEASUREMENT
RESULTS (LOAD/SAVE/
DELETE/RENAME)
The SJ-210 can save the measurement conditions and results. It
also can load the saved data.
The SJ-210 can save the measurement conditions and results in files and load the saved
data. It also can delete and rename the files.
Note that a memory card (optional) is necessary for saving/loading the measurement
conditions and results.
Using a memory card, the SJ-210 can save/load the measurement conditions up to 500
cases and the measurement results up to 10,000 cases of measurements.
This section explains the outline and procedures of loading/saving/deleting/renaming the
measurement conditions and results.
IMPORTANT
• A microSD card is used as the memory card.
microSD
TM
is the registered trademark of the SD Association.
A microSD Logo is the registered trademark.
In some parts of this manual, “microSD
TM
card” is described as “microSD card” or
“memory card”. While designed to comply with existing standards, due to standards
changes or additions, or the non-support of SPI mode, etc, some microSD cards may
not be supported. Use the SD card designated by Mitutoyo (Part No. 12AAL069).
• Before use, the memory card must be formatted using the SJ-210. The memory card
may not function properly when formatted in a device other than the SJ-210. For
information about formatting the memory card, refer to 10.10.1, “Formatting the memory
card”.
• Connect the AC adapter to prevent power to the instrument from being interrupted while
making settings.
• When using the built-in battery, make sure it is sufficiently charged. When operations
are performed while the battery power is low, the SJ-210 may shut off during operation.