Mitutoyo SJ-210 - Modifying the Roughness Standard

No. 99MBB122A
7-4
7.2 Modifying the Roughness Standard
The SJ-210 is compatible with each of the following roughness standards: JIS1982,
JIS1994, JIS2001, ISO1997, ANSI, and VDA.
TIP
• The currently specified roughness standard is indicated on the upper portion of the
Home screen.
■ Operating procedure (Refer to “■ Accessing the Measurement Conditions screen” in Section 7.1.)
Home screen to Main Menu   
1 Select “Standard” with the [ ↑ ] [ ↓ ] keys, and press the [Enter/Menu]
key.
2 Select a roughness standard compatible with the target surface with
the [ ↑ ] [ ↓ ] keys, and press the [Enter/Menu] key.
 The selected roughness standard is displayed on the
Measurement Conditions screen.
NOTE
• Be careful when modifying the roughness standard, as
other measurement condition items may be automatically
modified as a result.
TIP
• Press the [Esc/Guide] key to return to the previous screen.
• When the Measurement Conditions screen has been
accessed using the shortcut [Red] key, pressing the
[Esc/Guide] key once returns you to the Home screen.
Measurement Conditions screen
Roughness Standard Setup screen
Measurement Conditions screen