13. SAVE / OUTPUT RESULTS USING [POWER/DATA] KEY
No. 99MBB122A
13-3
13.1.1 Connecting the SJ-210 and DP-1VR
IMPORTANT
• Before connecting the SJ-210 to the DP-1VR, turn off the DP-1VR's unit settings. For
information about DP-1VR unit settings, see the DP-1VR User's Manual.
Connect the SJ-210 and DP-1VR using the SPC cable according to the following
procedure.
1 Place your nail on the hollow provided on the rear cover, and push the rear cover in
the direction indicated by the arrow (1).
2 Pull the rear cover in the direction indicated by the arrow (2) and remove it.
Detaching the rear cover
3 Use the proprietary SPC cable to connect the SJ-210 to the DP-1VR.
Connecting the SPC cable
(1)
(2)
Rear cover
Data processor
DP-1VR
Connect to the INPUT data port
SPC connector
SJ-210
To Next Page
Loading...
