Mitutoyo SJ-210 - Modifying the Cutoff Length (ΛC)

No. 99MBB122A
6-20
6.5.4 Modifying the cutoff length (λc)
Set the cutoff length (λc) according to the precision roughness specimen.
■ Operating procedure (Refer to “■ Accessing the Calibration Menu screen” in Section 6.2.)
Home screen to Main Menu   
1 Select “Cal. Condition” with the [ ↑ ] [ ↓ ] keys, and press the
[Enter/Menu] key.
2 Select “λc” with the [ ↑ ] [ ↓ ] keys, and press the [Enter/Menu] key.
3 Select cutoff length which is compatible with the precision roughness
specimen with the [ ↑ ] [ ↓ ] keys, and press the [Enter/Menu] key.
 Selected cutoff length appears on the Calibration Condition Setup
screen.
TIP
• Press the [Esc/Guide] key to return to the previous screen.
Calibration Menu screen
Calibration Condition Setup screen
Cutoff Length Setup screen
Calibration Condition Setup screen