Mitutoyo SJ-210 - Setting the Printer Communication Conditions

13. SAVE / OUTPUT RESULTS USING [POWER/DATA] KEY
No. 99MBB122A
13-9
13.2.2 Setting the printer communication conditions
Printer communication conditions are set at the time of purchase. By connecting the
SJ-210 to the printer and performing a communication check, the printer's communication
settings are automatically configured, and printing can then be performed.
NOTE
• Only PT-1 printers support the communication check automatic configuration function.
TIP
• For information about connecting the SJ-210 and printer, refer to 13.2.1, “Connecting
the SJ-210 and printer”.
■ Operating procedure (Refer to “■ Accessing the Operating Environment Setup Menu screen” in Section
10.1.)
Home screen to Main Menu  
1 Select “Data Output” with the [ ↑ ] [ ↓ ] keys, and press the [Enter/Menu]
key.
2 Select “Printer” with the [ ↑ ] [ ↓ ] keys, and press the [Enter/Menu] key.
NOTE
• The factory default setting for data output is “SPC”. when
using a printer for data output, be sure to change the output
setting to “Printer”.
3 Press the “COMCheck” ([Red] key).
 A confirmation message is displayed.
Operating Environment
Setup menu screen
Data Output Setup screen
Print Setup screen