Mitutoyo SJ-210 - Setting Calculation Conditions When Mr[C] (Tp for ANSI) Is Selected

No. 99MBB122A
8-24
8.4.4 Setting calculation conditions when mr[c] (tp for ANSI) is selected
When the parameter “mr(c)” (“tp” for ANSI) is selected, the slice level must also be set as a
calculation condition.
■ Operating procedure (Refer to “■ Accessing the Submenu screen” in Section 8.1.)
Home screen to Main Menu   
1 Select “DetailsSetting” with the [ ↑ ] [ ↓ ] keys, and press the
[Enter/Menu] key.
2 Select “mr(c)” (“tp” for ANSI) with the [ ↑ ] [ ↓ ] keys, and press the
[Enter/Menu] key.
3 Select the reference for the slice level, and press the [Enter/Menu] key.
“Peak”: Set from the highest peak of the evaluation profile
“Base”: Set from the mean line of the evaluation profile
 The background of the selected slice level reference turns blue.
Submenu screen
Setting Details Selection screen
mr(c) Setup screen
mr(c) Setup screen