No. 99MBB122A
4-6
4.3.2 Starting measurement
NOTE
• Measurement can not be started when the low battery voltage alarm indicator is
flashing. Connect the AC adapter, or charge the battery. Refer to 3.4, “Power Supply” for
details.
■ Operation procedure
1 Press the [START/STOP] key on the Home screen.
The detector starts traversing to perform measurement.
While measurement is being performed (detector is traversing), the
Measurement Waveform Display screen is displayed.
NOTE
• Press the [START/STOP] key during measurement to stop
for unavoidable reasons.
After the measurement has been completed, the measured value
is displayed.
TIP
• For information about the measurement results, refer to
Chapter 5, “MEASUREMENT RESULT DISPLAY”.
Measurement Waveform Display screen
Home screen
Home screen
To Next Page
Loading...
