Mitutoyo SJ-210 - Setting Calculation Conditions When Mr Is Selected

8. MODIFYING PARAMETERS
No. 99MBB122A
8-21
8.4.3 Setting calculation conditions when mr is selected.
When the parameter “mr” is selected, the number of sections, reference line, and slice level
must also be set as calculation conditions.
TIP
• The calculation results for parameter “mr” are displayed according to the set number of
sections (N).
• Parameters “mr(Rz)” and “mr(Rt)” can be set when the roughness standard is “Free”.
■ Operating procedure (Refer to “■ Accessing the Submenu screen” in Section 8.1.)
Home screen to Main Menu   
1 Select “DetailsSetting” with the [ ↑ ] [ ↓ ] keys, and press the
[Enter/Menu] key.
2 Select “mr” with the [ ↑ ] [ ↓ ] keys, and press the [Enter/Menu] key.
3 Set the number of sections.
a Use the [ ↑ ] [ ↓ ] keys to select “Slice points”.
Submenu screen
Setting Details Selection screen
mr Setup screen