Mitutoyo SJ-210 - SETTING UP THE SJ-210

No. 99MBB122A
3-1
3 SETTING UP THE SJ-210
This chapter explains the attachment procedure and the initial
settings of the drive/detector unit.
3.1 SJ-210 Settings
The following settings must be made before making measurements with the SJ-210.
 Installing the drive/detector unit and the detector
The SJ-210 is shipped with the display unit, detector, and drive unit packed separately.
Connect the three units with connecting cables.
This section explains how to attach and detach the drive/detector unit.
 Applying the display protection sheet
Apply the display protection sheet on the display of the display unit.
This section explains how to attach the display protection sheet.
 Turning on the power supply
Recharge the built-in battery of the display unit and turn the power on.
This section also explains turning the power of/off during usual operations.
 Initial settings
Set up the items such as the date (including the time) and the display language.
 Using the carrying case
For safe use of the SJ-210, put the display unit in the carrying case,
following the procedures given in this chapter.