Mitutoyo SJ-210 - Plugging in and Unplugging the Display Unit Cable

No. 99MBB122A
3-8
3.2.3 Plugging in and unplugging the display unit cable
IMPORTANT
• These connections (or disconnections) should be made while the power to the SJ-210 is
off (or in the auto-sleep mode).
■ Disconnecting the display unit cable
1 Slide the section to be held in the direction indicated by the arrow (1) and remove
the drive/detector unit connection plug from the socket connector at the rear of the
drive/detector unit.
Disconnecting the display unit cable
■ Connecting the display unit cable
1 After confirming the orientation of the socket connector (pin positions) at the
drive/detector unit and that of the drive/detector unit connection plug (pin positions),
insert the plug into the connector.
Connecting the display unit cable
Drive/detector unit
Display unit cable
Drive/detector unit
connection plug
Section to be held
Rear of drive/detector unit
Connector
Drive/detector unit
Connector
Display unit cable
Section to
be held
Drive/detector unit
connection plug
(1)